I cleared one PIR serial number and created a tamper to automatically reconnect the PIR using (52 | 5 | select zone | *) but the unit does not recognise the PIR serial number PIRs are still linked to (registered on) the unit (checked 52 | 5 |1 (Serial number)). Checked the reading strength for the detectors (menu 21 | go to zone | #). On pressing the Full/Part set buttons no signal is picked up & recognised by the Galaxy unit Checked if the wireless fobs (TCB800m) work. Restarted the unit (51 | 17) but the problem persists I have the engineer’s code and done the following: I have restarted the Galaxy unit but the problem still persists. The batteries in the PIRs are all working well (checked voltage with multimeter) and the PIRs appear to be working.
The noise just continued uninterrupted until I cancel with Esc. Now when I enter my code and press A/> to set the unit before going out the unit/speakers give the noise as usual but when I leave I do not hear the three beeps to indicate the alarm has been set to active. It has been working perfectly with no issues, but recently it has developed a fault that I hope someone can help resolve. I have a Honeywell Galaxy 2-20 alarm with wireless PIRs.
